FAQ
Why do you need preventative maintenance? Over the years, we have learned that most heating and air conditioning systems have energy wasting problems that can be corrected through regularly scheduled preventative maintenance. Well documented studies have shown that:
What is the best temperature to keep my thermostat set at? The only correct temperature for your thermostat is the one you are most comfortable with. Just remember that every degree cooler you have it set could raise your energy bill about 3%.
What is a SEER rating? Cooling efficiency for air conditioners is indicated by a SEER (Seasonal Energy Efficiency Ratio) rating, which tells you how efficiently a unit uses electricity; the higher the number, the greater the efficiency. The typical SEER rating of units manufactured prior to 1992 is about 6.0. In 1992, the government established the minimum cooling efficiency standard for units installed in new homes at 10.0 SEER. Then again in 2006 established for 13 SEER. High-efficiency units have a SEER of at least 13.0; the maximum available is about 20.0 SEER.
Will a new air conditioner and furnace lower my bills? YES! A new air conditioner can cut electrical consumption as much as 50%. Even a 13 SEER air conditioner will cut the electricity used by as much as 30%. A new 90% furnace can usually cut the gas used by the old furnace by as much as 30%, and a new 80% (minimum allowed by the federal government) will use approximately 20% less.
What is Freon R-22? R-22 is the common name from hydro-chlorofluorocarbon (HCFC). R-22 has been used as a refrigerant by HVAC manufacturers for over 40 years, but studies in the past decade have shown that HCFC’s contain chlorine, an ozone-depleting agent. For this reason, the United States Clean Air Act set a target date for January 1, 2010, on which HVAC manufacturers had to cease the production of products that use R-22.
What is R-410A? R-410A is the common name for an emerging hydro-fluorocarbon (HFC) that is being used as a refrigerant in the HVAC industry. R-410A is more environmentally friendly than R-22 and is being seen as the most likely replacement for R-22 by HVAC manufacturers. At the beginning of 2010, the use of alternate refrigerant was required in HVAC manufacturing.
What can I do to control the humidity levels in my home? Humidity levels can be reduced by operating a variable speed air handling system in your home. Variable speed units run longer, at lower speeds, allowing air to constantly circulate against the cooling coil and remove more moisture. Variable speed motors also use less electricity than regular motors, reducing your energy costs.
What is a heat pump? A heat pump is a device used for either the heating or cooling of a space by transferring hot and cold between two reservoirs. A heat pump can act like an air conditioner, transferring heat from inside to out, or like a heater as it transfers exterior heat to the interior. A winter day with a temperature of 32° Fahrenheit still produces enough heat to warm a space when the air is transferred by heat pump.
What is AFUE? AFUE is the abbreviation for Annual Fuel Utilization Efficiency ratio. AFUE is used to rate furnace efficiencies by dividing the ratio of heat output by heat input. This measurement describes how well fuel, gas or oil is consumed to produce heat by a furnace. As the AFUE rate increases, the efficiency of your furnace also increases, lowering your fuel costs. Furnaces manufactured in the United States are required to have at least an 80% AFUE.
How long will my system last? Maintenance and service play a key role in the life cycle of a heating or air conditioning system. If all recommended maintenance and service actions are taken, it is believed that an air conditioner should last 12-15 years, and a gas furnace should last from 20 to 25 years.
What happens when I replace my old system? To install the most efficient HVAC system in your household, a detailed inspection should first be performed by your installation contractor. The inspection should include, as a minimum, the inspection of your home’s ductwork, insulation, refrigerant piping, electrical service, wiring, thermostat, condensate piping, flue piping, flue terminations, slabs, filters, driers, registers, grills, drain pans and evaporator coil.
How do I determine the size or capacity of my HVAC system? Factors affecting the size of your new system include the climate in your region, humidity levels, the number and kind of windows in your dwelling, total square footage of your home, the direction your home faces, the number of heat producing appliances in your home, the type of insulation you have and the number of people that live in your residence.
What goes into installing a new system? If you install a new system, most of the items from the “What happens when I replace my old system?” will need to be installed as well. Beyond equipment, the most important component installed with a new system is the ductwork.
Contact us for more information! We look forward to hearing from you!
- 1/100th of an inch of dirt on an evaporator coil can increase operating costs by 5%
- A dirty blower wheel can reduce air flow by over 30% which causes the unit to run longer
- A 23% refrigerant undercharge can cause the unit to operate less efficiently by up to 52%
- Improper refrigerant undercharge will cause premature compressor failure
- A small air leak in your return air ducts with a 120 degree attic can double operating cost
- The bottom line is: Preventative maintenance saves you money!
What is the best temperature to keep my thermostat set at? The only correct temperature for your thermostat is the one you are most comfortable with. Just remember that every degree cooler you have it set could raise your energy bill about 3%.
What is a SEER rating? Cooling efficiency for air conditioners is indicated by a SEER (Seasonal Energy Efficiency Ratio) rating, which tells you how efficiently a unit uses electricity; the higher the number, the greater the efficiency. The typical SEER rating of units manufactured prior to 1992 is about 6.0. In 1992, the government established the minimum cooling efficiency standard for units installed in new homes at 10.0 SEER. Then again in 2006 established for 13 SEER. High-efficiency units have a SEER of at least 13.0; the maximum available is about 20.0 SEER.
Will a new air conditioner and furnace lower my bills? YES! A new air conditioner can cut electrical consumption as much as 50%. Even a 13 SEER air conditioner will cut the electricity used by as much as 30%. A new 90% furnace can usually cut the gas used by the old furnace by as much as 30%, and a new 80% (minimum allowed by the federal government) will use approximately 20% less.
What is Freon R-22? R-22 is the common name from hydro-chlorofluorocarbon (HCFC). R-22 has been used as a refrigerant by HVAC manufacturers for over 40 years, but studies in the past decade have shown that HCFC’s contain chlorine, an ozone-depleting agent. For this reason, the United States Clean Air Act set a target date for January 1, 2010, on which HVAC manufacturers had to cease the production of products that use R-22.
What is R-410A? R-410A is the common name for an emerging hydro-fluorocarbon (HFC) that is being used as a refrigerant in the HVAC industry. R-410A is more environmentally friendly than R-22 and is being seen as the most likely replacement for R-22 by HVAC manufacturers. At the beginning of 2010, the use of alternate refrigerant was required in HVAC manufacturing.
What can I do to control the humidity levels in my home? Humidity levels can be reduced by operating a variable speed air handling system in your home. Variable speed units run longer, at lower speeds, allowing air to constantly circulate against the cooling coil and remove more moisture. Variable speed motors also use less electricity than regular motors, reducing your energy costs.
What is a heat pump? A heat pump is a device used for either the heating or cooling of a space by transferring hot and cold between two reservoirs. A heat pump can act like an air conditioner, transferring heat from inside to out, or like a heater as it transfers exterior heat to the interior. A winter day with a temperature of 32° Fahrenheit still produces enough heat to warm a space when the air is transferred by heat pump.
What is AFUE? AFUE is the abbreviation for Annual Fuel Utilization Efficiency ratio. AFUE is used to rate furnace efficiencies by dividing the ratio of heat output by heat input. This measurement describes how well fuel, gas or oil is consumed to produce heat by a furnace. As the AFUE rate increases, the efficiency of your furnace also increases, lowering your fuel costs. Furnaces manufactured in the United States are required to have at least an 80% AFUE.
How long will my system last? Maintenance and service play a key role in the life cycle of a heating or air conditioning system. If all recommended maintenance and service actions are taken, it is believed that an air conditioner should last 12-15 years, and a gas furnace should last from 20 to 25 years.
What happens when I replace my old system? To install the most efficient HVAC system in your household, a detailed inspection should first be performed by your installation contractor. The inspection should include, as a minimum, the inspection of your home’s ductwork, insulation, refrigerant piping, electrical service, wiring, thermostat, condensate piping, flue piping, flue terminations, slabs, filters, driers, registers, grills, drain pans and evaporator coil.
How do I determine the size or capacity of my HVAC system? Factors affecting the size of your new system include the climate in your region, humidity levels, the number and kind of windows in your dwelling, total square footage of your home, the direction your home faces, the number of heat producing appliances in your home, the type of insulation you have and the number of people that live in your residence.
What goes into installing a new system? If you install a new system, most of the items from the “What happens when I replace my old system?” will need to be installed as well. Beyond equipment, the most important component installed with a new system is the ductwork.
Contact us for more information! We look forward to hearing from you!